Filter
Top Products
INSTALLATION STEP 11
Fasten the Door Bracket
Follow instructions which apply to your door type
as illustrated below or on the following page,
A horizontal reinforcement brace should be long
enough to be secured to two vertical supports. A
vertical reinforcement brace should cover the
height of the top panel.
The illustration shows one piece of angle iron as the
horizontal brace. For the vertical brace, two pieces of
angle iron are used to create a "U"-shaped support
(Figure 1). The best solution is to check with your
garage door manufacturer for an opener installation
door reinforcement kit.
NOTE: Many vertical brace installations provide for
direct attachment of the clevis pin and door arm. In
this case you will not need the door bracket; proceed
to Installation Step 12.
SECTIONAL DOORS
• Center the door bracket on the previously marked
vertical centerline used for the header bracket
installation.Note correct UP placement, as
stamped inside the bracket (Figure 2).
• Position the bracket on the face of the door within
the following limits:
A) The top edge of the bracket 2"-4" below the top
edge of the door.
B) The top edge of the bracket directly below any
structural support across the top of the door.
' ONili,'ii!i! ii ii!!
Topreventdamageto garagedoor, reinforceinsideof
doorwith angle iron bothvertically andhot z0ntaly.
HARDWARE SHOWN ACTUAL SIZE
LltlLilitlt!l!l!i!,!illtltll!lJtt!lt
5/16"-18×2-1/2"
• Mark and drill 5/16" left and right fastening holes.
Secure the bracket as shown in Figure 1 if there is
vertical reinforcement.
if your installation doesn't require vertical reinforce-
ment but does need top and bottom fastening holes
for the door bracket, fasten as shown in Figure 2.
_dHeader Bracket ...--" ° """"""" ° °""" "÷"
. .. °° °"" Horizontal and vertical reinforcement
.÷-°'_° is needed for ligh_eight garage doOrs
r "_
5/16" Nut '
Figure 2
24