Filter
Top Products
I I I
Template
Holder
/
Template Advance Knob Fig. 3
3. Insert a template into the slot of template
holder. Select the proper size of button-
hole by turning the template advance
knob.
Fig. 4
4. Pull the guide plate all the way forward so
that the guide pin is at °'S". This will
enable you to start at one end of the
buttonhole. Drop guide plate into place
over the pinion gear,
Fig. 5
.
Pick up bobbin thread through guide plate
by turning hand wheel and drawing
thread to back of machine. Place fabdc
between presser foot and guide plate.
Line up edge of fabric with marked
indentation on guide. If you wish all
buttonholes to be 3/4 inch from edge of
garment, line up fabric with 3/4 inch
marking each time you start sewing a
buttonhole.
44