Sanyo XHS2432 Air Conditioner User Manual


 
11
OI-212-11EG
Using the Remote Control Unit
How to Install Batteries
1. Slide the cover in the direction indicated by the arrow
and remove it.
2. Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the battery
compartment.
3. Use a thin object such as the tip of a pen to press the
ACL button.
NOTE
The batteries last about six months, depending on how much you use the
remote control unit. Replace the batteries when the remote control unit’s
display fails to indicate, or when the remote control cannot be used to
change the air conditioner’s settings.
Use two fresh leak-proof type-AAA alkaline batteries.
In replacing batteries, follow the instructions as mentioned in the
sub-section “How to Install Batteries”.
If you do not use the remote control unit more than 1 month, take out the
batteries.
How to Use the Remote
Control Unit
When using the remote control unit, always point the unit’s transmitter
head directly at the air conditioner’s receiver.
(Transmitter head)
Remote Control Unit
Installation Position
The remote control unit may be operated either from a non-fixed position
or from a wall-mounted position. To ensure that the air conditioner operates
correctly, DO NOT install the remote control unit in the following places:
DO NOT
In direct sunlight
Behind a curtain or other places where it is covered
More than 26 feet (8 m) away from the air conditioner
In the path of the air conditioner’s airstream
Where it may become extremely hot or cold
Where it may be subject to electrical or magnetic noise
Where there is an obstacle between the remote control unit and air
conditioner (since a check signal is sent from the remote control unit every
5 minutes)
ACL button
Remote control
unit
Receiver
Air conditioner
(Indoor unit)