Filter
Top Products
13
ADJUSTING THE AIRFLOW
DIRECTION
1. Horizontal
The horizontal airflow can be adjusted by moving the vertical
vanes with your hands to the left or right. Always use the knobs
located at the top of the center vanes on the left and right sides to
adjust the airflow direction.
When the humidity is high, the vertical vanes should be in the
front position during the cooling or dehumidifying operation.
If the vertical vanes are positioned all of the way to the right
or left, condensation may begin to form around the air vent
and drip down.
2. Vertical
The vertical airflow can be adjusted by moving the flap with the
remote control unit. Do not move the flap with your hands. Confirm
that the remote control unit has been turned on. Use the FLAP
button to set either the sweep function or one of the six airflow
direction settings.
• The flap automatically closes when the unit is off.
• Use the FLAP button on the remote control to adjust the
position of the flap. If you move the flap by hand, the flap
position according to the remote control and the actual flap
position may no longer match. If this should happen, shut
off the unit, wait for the flap to close, and then turn on the
unit again; the flap position will now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the air
vent and drip down.
OPERATION WITHOUT THE
REMOTE CONTROL UNIT
If you have lost the remote control unit or it has trouble, follow the
steps below.
When the air conditioner is not running
Each time the OPERATION button is pressed, the operation mode
changes cyclically.
Knob
CAUTION
COOL
DRY
SWEEP
FAN
SWEEP
A. Sweep function
The flap starts moving up and down to deliver air
over the sweep range.
B. Setting the airflow manually
Referring to the above illustration, use the FLAP
button to set the airflow direction within the range
used during the cooling or dehumidifying operation.
C. Auto flap function
The flap is set to the recommended position.
NOTE
CAUTION
OPERATION
TIMER
ON/OFF
INDOOR UNIT
OPERATION
button
(ON/OFF)
Cooling
operation
Stop
OI-018-13-EG
SAP-K97GAX_EN.fm Page 13 Tuesday, January 22, 2008 6:34 PM