Filter
Top Products
Adjusting the Airflow Direction
A. Horizontal (Wall mounted type only)
The horizontal airflow can be adjusted by moving the vertical vane to the
left or right.
B. Vertical
Confirm that the remote control unit has been turned on. Press the FLAP
button to start the flap moving up and down (
). If you want to stop the
flap movement and to direct the air in the desired direction, press the FLAP
button again. In the COOL mode, don’t direct the flap down more than 30 °
(KS, TS Types), or leave it in the vertical position (XS Type), otherwise
condensation may drip onto the floor. Zone ‘‘A’’ (KS, TS Type) and any
position other than vertical (XS Type) are the recommended flap positions
for cooling.
CAUTION
Do not move the flap with your hands.
Operation without the Remote
Control Unit
If you have lost the remote control unit or it has trouble, follow the steps
below.
1. When the air conditioner is stopped.
If you want to turn on the air conditioner, switch the operation selector to
the OFF position, and then to the ON position.
NOTE
The set temperature and fan speed are automatically set at the
last selection before stopping.
2. When the air conditioner is running.
If you want to turn off the air conditioner, switch the operation selector to
the OFF position.
Indoor unit
(Wall mounted type)
Zone
‘‘A’’
for
COOLING
Left
Vertical
vane
Right
30°
Flap
Air outlet
grille
Down
Up
ON I /OFF
MODE
FLAP
FAN SPEED
SELECT
HH TIMER
SELECT
MM
TIME SET
NIGHT
SETBACK
BATTERIES
ACL
A/C
SENSOR
OFF ON
CLOCK
INDOOR UNIT
Operation
selector
Flap
(Wall mounted type)
20 OI-201-20EG