Filter
Top Products
Care and Cleaning (continued)
How to remove the filter
Ceiling mounted type:
1. Remove the bolt screws on the latch using a screwdriver. (After
cleaning, be sure to reattach the two bolt screws.)
2. Take hold of two latches on the air intake grille and press it to the rear,
and the grille will open downward.
3. Take hold of the finger-hold on the air filter, first lift it and then pull it
toward you to release it from the catch.
How to remove the filter Wall type
1. Move the flap on the air outlet grille to its lowest position.
2. Hold the air filter by the tab at the bottom, and pull downward.
How to clean the filter Use a vacuum cleaner to remove light dust. If there is sticky dust on the
filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and
dry it.
Outdoor Unit
CAUTION
1. Certain metal edges and the condenser fins are sharp and may
cause injury if handled improperly; special care should be taken
when you clean these parts.
2. Periodically check the outdoor unit to see if the air outlet or air
intake is clogged with dirt or soot.
3. The internal coil and other components of the outdoor unit must
also be cleaned periodically. Consult your dealer or service center.
Care: After a Prolonged Idle
Period
Check the indoor and outdoor unit air intakes and outlets for blockage; if
there is a blockage, remove it.
Care: Before a Prolonged Idle
Period
•
Operate the fan for half a day to dry out the inside.
•
Disconnect the power supply and also turn off the breaker.
•
Clean the air filter and replace it in its original position.
•
Outdoor unit internal components must be checked and cleaned
periodically. Contact your local dealer for this service.
Air filter
Air filter finger-hold
Air intake grille
Catch
Latch
Air filter
Pull down
22 OI-201-22EG