Filter
Top Products
4
Assemble Upper Handle
Hold the upper handle so it curves away from the cleaner.
Then push it down over the lower handle. Secure with the
other 2-part handle bolt (A).
Attach Lower Handle
Raise the dust cup support. Push the lower handle (largest
end down) through the tube of the dust cup support and into
the handle socket at the back of the cleaner. Make sure the
notches on the lower handle face the rear of the cleaner (Fig.
1). Align the holes, insert a 2-part bolt (A), and tighten.
A
A
Dust Cup
Support
Tube
Lower
Handle
Handle
Socket
Upper
Handle
Lower
Handle
Handle
Socket
A
A
Secure Cord Clamp
Secure the electrical cord to the dust cup support with the
cord clamp and screw (D). Place the cord clamp over the
electrical cord. Screw the clamp to the tab below the left
latch; start the screw by hand, then tighten.
Fig. 1
Toward Rear
of Cleaner
Attach Upper Cord Hook
Pull the spring on the electrical cord upward toward the
top of the handle. Make sure slots in handle are positioned
properly.
Insert the lower half of the spring into the upper cord hook,
as shown, Detail B. Snap the hook into the upper handle,
directions below.
Cord Storage
Loop the cord around the large single hook or the two
standard cord hooks (depending on model/series). Fasten
the plug to the cord to prevent unwinding.
Hook Bag Top
Slip the ring at the top of
the cloth bag over the bag
support hook on the back
of the cord hook.
Attach Lower Cord Hook
(680 Series Only)
Insert the power cord into the lower cord hook (A), as shown.
Snap the hook into the lower handle. Pull up on the cord to
tighten but leave enough slack near the base so the cord is
not strained when the handle is lowered.
A
1. Place
inner tab
into slot
2. Press hook
around
handle
3. SNAP opposite
inner tab into
place
Detail B