Samsung VCC88P0H1B Vacuum Cleaner User Manual


 
10_ maintaining the tools and fi lters
Vacuums dust in a
wide area at once.
Remove waste matter completely from
the inlet if the inlet is blocked.
PARQUET BRUSH (OPTIONAL)
REPLACING the Drive Belt
1. Make sure that the vacuum is unplugged.
2. With the rotating fl oor brush removed from the vacuum
cleaner, grasp the old drive belt and remove it from the
motor pulley. Discard the old drive belt.
3. Place the new drive belt over the motor pulley and stretch
the other end over the rotating fl oor brush in the space
between the bristles.
4. Place the ends of the rotating fl oor brush down into the
slots on the sides as shown.
5. Turn the rotating fl oor brush by hand several times in the
direction of the motor pulley. If properly installed, the drive
belt will center itself on the rotating brush crown.
6. Reposition the brush cover and screws. Tighten the screws securely.
CHECKING the Rotating Floor Brush and Drive Belt
You should check your vacuum cleaner’s rotating fl oor brush and drive belt regularly for
wear or damage. You should also clean strings, hair, and carpet fi bers off the brush and
brush ends. These can wrap around the brush and hamper its ability to effectively clean
your carpet. Also remove any debris that has accumulated under the brush cover.
1. Unplug the vacuum from the electrical outlet.
2. Place the handle in low position and turn the vacuum
cleaner over so the bottom side is up.
3. Remove the six screws (at arrows, right) with a screwdriver.
4. Remove the brush cover from the fl oor brush.
5. Grasp the rotating fl oor brush at both ends and lift.
6. Clean string, hair and other debris off the rotating fl oor
brush, paying particular attention to brush ends.
7. Clean string, hair and other debris off the motor pulley and
drive belt areas.
8. Check the drive belt carefully for wear, cuts or stressed
areas.
9. Check the air passageway for obstructions. Remove
debris from this area.
The rotating fl oor brush could cause the fringe of a rug
to become tangled within the vacuum.
Use caution and turn off the fl oor brush when
vacuuming throw rugs with fringe.
Brush
Brush
Cover
Cover
CAUTION
MAINTAINING FLOOR TOOLS