Filter
Top Products
10_ Operating the cleaner
The Power on/off button is located on the top body.
Turn on vacuum by power button after plugging cord into electrical outlet.
The vacuum is automatically controled by the dirt senser.
The dirt sensor is automatic power control by dust amount.
There are 3 suction power levels by power control button.
The Power foot brush on/off button turns the rotating brush roll on and off.
Turn brush roll switch on to clean carpet and rugs.
Turn brush roll switch off to clean hard surface floors.
The brush rolls will automatically turn off when the handle is in the upright position.
Operating the cleaner
Power switch/Power foot brush roll switch
The circuit breaker turns off the brush rolls if there is an obstruction in them.
The brush rolls will not turn, but the suction motor will continue to run.
To reset the breaker, turn cleaner off and unplug it. Clear obstruction.
Press circuit breaker switch to the on position. Turn cleaner on and continue
cleaning.
Circuit breaker (Reset switch)
Pipe release
Dust bin release
Power control
Brush roll on/off
Power ON/OFF