Filter
Top Products
E-
22
Cooling Your Room
To select the COOL mode, press the Mode button until is displayed
at the top of the wireless remote controller.
Result:
◆ The indoor unit beeps.
◆ The air conditioner runs in COOL mode.
2
You can change modes at any time.
To adjust the temperature, press the
Temperature
buttons one or more
times until the required temperature is displayed. Possible temperatures
are between 18
O
C and 30
O
C inclusive.
Result:
◆ Each time you press
Temperature
buttons:
- The temperature is adjusted by 1
O
C.
- The indoor unit beeps.
◆ The air conditioner starts cooling, provided that the room
◆ temperature is higher than the selected temperature ; the fan
◆ will, however, operate.
3
You must select the COOL mode if you wish to adjust the :
◆ Cooling temperature
◆ Fan speed when cooling
1
If necessary, press (ON/OFF) button.
Result:
◆ The On/Off indicator on the unit comes on.
◆ The air conditioner runs in the mode selected when the
unit was last used.
◆ The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after three minutes.
IMPORTANT
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
4
To control the direction of the air flow, refer to page 25.
5
NN
NN
oo
oo
tt
tt
ee
ee
Automatic(rotated : ➔➔)
Low
Medium
High