Filter
Top Products
EN-8
3. Replacing the Brushroller Belt
Use with caution when replacing the that drives the brushroller. Tension on the
belt is high.
3. Checking the Performance of the Power Brush
You may check whether the power brush is operating correctly by lifting up the
extension tube slightly to view the back of the brush.
The Power Brush will not operate when it is jammed or the unit is turned off.
If the Power Brush is jammed, Unplug the power cord from the electrical outlet.
Turn power brush over and remove the jammed object.
Turn the power brush back to vacuuming position and resume vacuuming
CAUTION:
Do not invert the power brush while it is running
MAINTAINING THE POWER BRUSH
1. Removing the Brush Cover
• Before replacing any parts, unplug the vacuum clean-
er from the electrical outlet.
• Remove 6 screws from the bottom plate and open the
brush cover.
2. Replacing the Headlight Bulb(optional)
2) Remove the old bulb from the bulb
socket. Insert the new bulb. You
can use a vacuum cleaner lamp
rated 120V, 20W.
1) Remove the Brush Cover as described
below.
DJ68-00079J 7/2/01 11:30 AM Page 10