Filter
Top Products
16_ installing
installing your air conditioner
GETTING READY TO INSTALL THE AIR CONDITIONER
First select a room and check conditions prior to installation.
Checking included parts
Check that all necessary parts are included. Actual accessories may slightly differ from the
illustration shown below.
Gasket Drain tube Rubber cap Screws
Selecting the best location
The unit should be level when installed, so that the drainage system and other mechanisms
operate efficiently. If possible, install the unit in a shaded area on the home’s north or east side.
Before installation, select a location that fulfills these requirements:
• easy access to control panel.
• away from direct exposure to sunlight.
• adequate ventilation.
• can easily connect to a power source.
• can support the weight of the air conditioner and will not cause increased operating noise
and vibration.
• where there is no obstacles near the air inlet and outlet.
• the bottom of the unit clears at least 750mm above ground level.
500mm 500mm
750mm
75mm
min.
300mm
500mm
about 3˚
150mm min.
145mm
awning
If the wall is thicker than 150mm,
cut the back of the wall at 45°.
100mm or more
Outdoor side
Indoor side
45˚ 45˚
outdoor sideindoor side
<Fence, wall
or other
obstacles>