Filter
Top Products
E-11E-
Removing Excess Humidity
The air conditioner starts up in the Cool mode.
If the atmosphere in your room is very humid or damp,you can remove
excess humidity without lowering the room temperature too much.
If necessary, press the (On/Off) button.
Result:
The unit beeps twice.
1
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
It will start up normally after three minutes.
To adjust the temperature, press the or buttons one or
more times until the required temperature is displayed.
Possible temperatures are between 64 F and 86 F inclusive.
2
3
4
To control the direction of the air flow, refer to page 24.
Result:
Each time you press the or buttons:
- The temperature is adjusted by 1 F
- The unit beeps
The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
If the temperature is not displayed on the control panel:
press the button the unit one or more times until the
temperature is displayed.
You can change modes at any time.
Result:
Power
Control Panel
The air conditioner starts up in the cool mode.
The unit beeps each time you press the button.