Filter
Top Products
E-14
Installation (Cont.)
Attach the seal strip to the window.
4-1 Cut the adhesive-backed foam seal strip gasket to the window width.
4-2 Remove the backing from the seal strip and attach the strip to
the underside of the bottom window.
4
Rubber Cap
Rear
Rear
Rubber Cap
Drain Plug
Gasket
Drain Hose
4˚
Drain system installed Decreased Decreased
Cooling capacity Noise
Without drain system installed Increased
Increased
Install the drain plug. (The unit does not require any separate drain system.
However, a separate drain plug can be installed if needed.)
5-1 Remove the rubber cap inserted into the basepan.
5-2 Fix the drain plug as shown in the figure, and then connect the drain
hose.(You can use any commercially-available drain hose.)
5
Install the unit in the window.
6-1 Place the air conditioner cabinet into the window with the top
support channel positioned just in front of the bottom sash.
6-2 Center the cabinet, side to side in the window then pull the window
down until it rests on the air conditioner, just behind the mounting
channel front flange on top of the cabinet.
6-3 Make sure the cabinet maintains a slightly downward slant to
the outside. A 4˚ slant, cabinet front to rear is desirable to help
prevent water from entering the room.
6