Filter
Top Products
You must select the COOL mode if you wish to adjust the:
◆
Cooling temperature
◆
Fan speed when cooling
1 If necessary, press the ON/OFF( ) button.
Result:
◆
The power indicator on the control panel comes on.
◆
The indoor unit beeps twice.
◆
The operation mode previously set is displayed.
◆
The air conditioner starts up in the mode selected
when the unit was last used.
IMPORTANT
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆
Switched on
◆
Stopped
It will start up normally after a three-minute rest period.
2 If the COOL indicator is not displayed, press the MODE button one
or more times until it appears.
Result:
◆
The indoor unit beeps each time you press MODE.
◆
The air conditioner starts up in COOL mode.
To operate the unit by remote control, press the COOL button.
NN
NN
oo
oo
tt
tt
ee
ee
◆
You can change modes at any time.
3 If the “SET TEMP” and “TEMP” indicators are not displayed,
press the TIME/TEMP. SELECT button to appear it.
4 To adjust the temperature, press the TIME/TEMP. ▲ or ▼ buttons
one or more times until the required temperature is displayed.
Possible temperature are between 18°C(65˚F) and 30°C(86˚F) inclusive.
Result:
◆
Each time you press the TIME/TEMP. ▲ or ▼.
- The temperature is adjusted by 1°C
- The indoor unit beeps.
◆
The air conditioner will only start cooling if the room
temperature is higher than the selected temperature.
5 Select the fan speed by pressing the FAN SPEED button one or more
times until the required setting is displayed:
Low
Medium
High
To select the fan speed by remote control, press LOW, MID or HIGH buttons.
NN
NN
oo
oo
tt
tt
ee
ee Each time you press FAN SPEED, the indoor unit beeps.
6 To control the air flow direction when necessary, refer to page 14.
Cooling Your Room
E-11