Filter
Top Products
Heating Your Room
(Except Cooling Only Models)
To select the HEAT mode, press the Mode button until is displayed
at the top of the wireless remote controller.
Result:
◆ The indoor unit beeps.
◆ The air conditioner runs in HEAT mode.
2
You can change modes at any time.
To adjust the temperature, press the
Temperature
buttons one or more
times until the required temperature is displayed. Possible temperatures
are between 61
O
F and 86
O
F inclusive.
Result:
◆ Each time you press
Temperature
buttons:
- The temperature is adjusted by 1
O
F.
- The indoor unit beeps.
◆ The air conditioner starts heating, provided that the room
temperature is lower than the selected temperature ; the fan
will, however, operate.
3
You must select the HEAT mode if you wish to adjust the :
◆ Heating temperature
◆ Fan speed when heating
1
If necessary, press (ON/OFF) button.
Result:
◆ The On/Off indicator on the indoor unit comes on.
◆ The air conditioner runs in the mode selected when
the unit was last used.
◆ The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after three minutes.
IMPORTANT
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
4
To control the direction of the air flow, refer to page 17.
5
NN
NN
oo
oo
tt
tt
ee
ee
E-14
Automatic(rotated : ➔➔)
Low
Medium
High
You can select the HEAT mode only in heat pump models.