Filter
Top Products
12 788 928 9
Saab 9-3 M03-
22 Unplug the connector from the air mass sensor,
separate the intake hose and remove the air fil-
ter cover. Remove the hose from the air filter
cover (if such a hose is fitted).
23 Remove from the turbo intake pipe the small
hose to the control valve (APC valve) and the
hose to the carbon filter vent-valve. Remove the
intake pipe.
24 Remove the heat shield from the turbo compres-
sor (two screws and a catch).
25 Remove the coolant hoses from the connections
to the heat exchanger and remove from the ther-
mostat housing the hose which is nearest to the
expansion tank.
26 Fit the heater mounting bracket to the bulkhead.
Tightening torque 24 Nm (18 lbf ft)
Using benzine, clean an area between the sus-
pension strut mounting bolts on the top of the
right-hand suspension turret nearest to the
engine. Remove the extra label from the heater
and affix it to the cleaned area.
Important
Retain the hose clip, it is required for re-assembly.
F920A016
2322 23 24
22
26
26
26
22
23
25
Important
Under no circumstances may this label conceal
any part of another label or plate.