Filter
Top Products
Operation
Display Panel on PAC
Auxiliary Power Control
The power control turns the unit on and off. When you press power control, the unit begins to operate. Note: You
will not have access to all functions without the remote control.
Warning Light
Condensed water may accumulate in the unit. If the internal tank fills, the warning light will shine and the unit will
not operate until the unit has been drained.
Operating Mode Indicator
When cooling mode is selected, the indicator light will shine blue. When the dehumidify mode is selected, indicator
light will shine blue. When fan mode is selected, indicator light will shine green.
Temperature and time setting indicator
1. During operation, the unit displays “present room temperature. ”
2. When setting temperature, the unit will display the temperature. Temperature setting range is 61°F to 89°F.
3. When setting the time it displays “set time” and indicator flashes.
4. 5 Seconds after “set temperature” and “set time”, display will return to “present room temperature.”
5. Temperature display ranges from 32°F to 89°F.
6. When temperature of the room is higher than temperature display range, the display shows “HI.”
7. When temperature of the room is lower than temperature display range, the display shows “LO.”
8. When the unit stops operating, indicator light goes off.
After switching the air conditioner off, you must wait 3 minutes before switching it back on
again.
Temperature and time
setting indicator
Operating mode indicator
Warning light
Receiving sensor
8