Filter
Top Products
S3
SECOND
MINUTE HOUR
S3 S3
- After all adjustments are completed, press S4 to exit setting mode.
- Press S1 to start the timer.
- When the timer is counting, press S1 can toggle between the display formats of timer.
S1 PRESET TIME
COUNT DOWN TIME
- Press S2 to stop the timer, or the timer will stop automatically when it counts down to zero. Then press S4 to
reload preset timer time or press and hold S2 for 2 seconds (“RST HOLD” displayed) to reset timer to zeros.
Remarks:
1. The timers are of 1-second resolution and with working range up to 23 hours 59 minutes 59 seconds.
2. “Loop” timer and count down stop timer cannot be used at the same time.
3. “Loop” timer or count down stop timer function can be selected only when the timers are reloaded or reset.
4. If preset timer time is less than 30 seconds, the watch will give out 1 “Beep” when timer counts down to zero.
And if preset timer time is equal to or more than 30 seconds, the watch will give out 10 “Beep” when timer
counts down to zero. Press any button can stop the “Beep” sound.
5. If there is no button operation for about 2 minutes in setting mode, the watch will return back to Timer mode
automatically.
6. If S5 is pressed in Timer mode, Time mode will be shown for 3 seconds and then return to the previous
display automatically.
7. To exit Timer mode, press S3 will enter mode selection display.
(G) HOW TO USE THE ALARM AND CHIME
S4 S1
S3 S2
S5
- At mode selection display, press S1 to enter Alarm mode, mode prompt “ALARM” will be displayed for 2
Seconds first.
- Press S2 to select “AL1” to “AL6” or “CHIME”.
- Press and hold S4 for 3 seconds (“SET HOLD” displayed) to enter setting mode. The hour digits start flashing.
- Press S1 (forward) or S2 (reverse) to adjust the flashing digits. Press and hold S1 or S2 for fast setting.
- Press S3 to select the next digits or T1/T2 for setting.
- When setting T1/T2, press S1 or S2 to toggle setting the alarm to refer to Normal Time mode (T1) or Dual Time
Mode (T2).
(1) Alarm 1 and alarm 2
- Alarm 1 and alarm 2 are daily alarms.
- As illustrated in the diagram, alarm 1 will sound at 7:30 AM of normal time (T1) daily.
- The setting sequence is shown as follow:
S3
HOUR MINUTE T1/T2
S3 S3
4