Filter
Top Products
24
Where should I install a remote outdoor sensor?
The remote outdoor sensor should be installed on the northern wall of your home, away from direct sunlight or other heat sources that
may affect its sensitivity.
Who should I call for additional help?
For additional troubleshooting information, visit our web site at www.about-i-series.com. To talk with a service representative, give us a
call at 800-445-8299.
What should I do if my power goes out?
Make sure your family is safe and don’t worry about the thermostat. Your thermostat automatically retains the time of day for approxi-
mately two hours in the event of a power outage. All other programmed parameters are stored permanently in memory. So, if your
power is out for more than two hours, simply reset the clock. See page 4.
How do I reset the thermostat program to factory conditions?
To reset the thermostat to factory conditions, press the UP button and the LEFT button at the same time. Hold for 3 seconds. The time
of day will display 12:00 indicating a reset has occurred.
NOTE: This will erase all programming and return the thermostat to the factory conditions including the installer settings.
Use this only as a last resort.
How do I know if the heating or cooling is on?
The display of the thermostat will indicate the operating mode, HEAT or COOL. When the temperature in your home decreases or
increases, the HEATING or COOLING cycle will come on based on the displayed mode. When the HVAC system is ON, the LEDs
along the bottom crease will turn on.
110-1023E.qxd 11/18/04 10:50 AM Page 24