Roberts Gorden EP-200 Series Heat Pump User Manual


 
SECTION 1: HEATING SYSTEM SAFETY
1
SECTION 1: HEATING SYSTEM SAFETY
Your Safety is Important to Us!
This symbol is used throughout
the manual to notify you of
possible fire, electrical or burn
hazards. Please pay special
attention when reading and follow-
ing the warnings in these sections.
Installation, Service and Annual Inspection of heater
and pump must be done by a contractor qualified in
the installation and service of gas-fired heating
equipment.
Read this manual carefully before installation, opera-
tion or service of this equipment.
This heating system is designed for heating nonresi-
dential indoor spaces. Do not install in residential
spaces. These instructions, the layout drawing, local
codes and ordinances, and applicable standards that
apply to electrical wiring, venting, etc., must be thor-
oughly understood before proceeding with the instal-
lation.
Thin sheet metal parts, such as the various venting
components, have sharp edges. To prevent injury,
the use of work gloves is recommended.
Do not attempt to operate the pump until all steps of
the installation have been accomplished.
1.1 Manpower Requirements
To prevent personal injury and damage to the pump,
two persons will be required for installation.