Filter
Top Products
OPERATING INSTRUCTIONS
-7-
-6-
• Beverage mixture should not include more than 50%
carbonated liquid, as this will adversely affect the operation of
the Beverage Fountain.
2. Add up to 1
1
/2 gallons of the prepared beverage to the BOWL.
• The BOWL holds up to 1
1
/2 gallons when filled to maximum
capacity.
• Once you complete these steps and the unit is running, you
may add up to 1 additional gallon of liquid to the BOWL
(capacity of unit during operation is up to 2
1
/2 gallons).
3. Plug the power transformer into an electrical outlet and plug the
connector into the BASE.
• The liquid will start flowing up through the OUTER TUBE and
then down through the spouts located in each TIER to create a
beautiful flowing fountain (at this point you may add up to 1
additional gallon of liquid).
• During operation, bubbles will be created and a four-colored
light will alternate colors through the INNER TUBE, adding to
the ambience of your event!
4. If you would like to refill the Rival
™
Beverage Fountain during the course
of your party, you may do so by adding more liquid to the BOWL.
5. IMPORTANT: Before shutting off the fountain, observe the liquid
level in the Bowl.
• If the Bowl is more than half full while the unit is running,
remove liquid until the Bowl is less than half full.
• Use a cup to transfer the excess liquid to a pitcher-this will
prevent overflow.
• After shutting off the fountain, if it appears that the fountain is
about to overflow, quickly plug it back in and remove more liquid.
The Rival
™
Beverage Fountain is designed to create a beautiful waterfall
of your favorite party beverage.
NOTE: • Rival
™
Beverage Fountain must be on a level surface to flow
properly.
•You may want to place a washable tablecloth under and
around the immediate area of the fountain, to protect against
light misting, splashing or accidental spills (especially if adding
food coloring to the punch).
1. Prepare your beverage according to one of the included recipes or
using your own favorite recipe.
OPERATING INSTRUCTIONS (CONT.)
4. Place each of the 4 DOMES over each STEM in the LARGE TIER
and press firmly into place.
5. Slide the LARGE and MEDIUM tiers over the OUTER TUBE. Then
slide the FLOW COLLAR and SMALL tier over the OUTER TUBE.
NOTE: •Tiers do not lock into place.
• Pay careful attention to the "THIS SIDE UP" markings on
the FLOW COLLAR during assembly. Position the FLOW
COLLAR so that the double arrows are facing upwards.
(See Figure. 3)
6. For best results and optimal waterfall effect, rotate each tier so the
spout placement is staggered.
NOTE: The liquid from the MEDIUM TIER should flow down
through each SPOUT and onto the DOMES.
7. If desired, you may hang each of the 12 included CUPS from the
rim of the Bowl. The included LADLE may be used to fill CUPS
with beverage.
IMPORTANT: Do not add liquid until product is fully assembled.
ASSEMBLING THE BEVERAGE FOUNTAIN (CONT.)
BF25006EM3.qxd 9/28/06 9:26 Page 7