Filter
Top Products
RiteTemp Internal Document
Page 14
Frequently asked Questions continued
For best cooling what speed should I run the fan?
The unit should be run in low for best possible cooling.
Can the unit be used as a fan only?
Yes, you can do this by turning just the fan switch and leaving the
pump switch in off.
Refill water light continues to blink, even though Water Tanks are full?
The water may not be flowing into the Base unit. Check side
tanks to make sure they are seated properly. When seated prop-
erly you should be able to hear water flowing into base unit.
Cooler Pad does not get wet after several minutes of operation.
Make sure that fan is running and that pump switch is in the on
position. It that is the case then the Water Distribution Holes may
be clogged. Turn Fan and Pump switches to off. Unplug unit from
wall. Remove filter assembly (see filter replacement section) Lo-
cate the drip tub clear the holes located on the bottom of the
tub and use a paper clip to clean them out.
Cooler Fan does not operate.
Make sure unit is fully
plugged into the outlet. Check
outlet to see if there is power
coming to it. If all looks good,
then the fan thermal overload
breaker may have activated;
unplug unit and wait 30 minutes
and try again.
Page 3
RiteTemp
Table of Contents
Bases of Operation 4
Basic Components 4
Unit Benefits 5
Filling the Cooler 6
Replacing Evaporative Cooler Filter 7
End of Season Maintenance and Storage 10
Hints for Better Cooling 12
Frequently asked Questions 13