Filter
Top Products
K-2000 Municipal Sewer Cleaning Machine
Ridge Tool Company • Elyria, Ohio • U.S.A. 5
WARNING
Never change power drive chain from one sprocket
to the other with engine/generator running.
Figure 2 – Power Drive Chain on Large Sprocket
6. Pull ratchet knob again to drop motor table into po-
sition, making sure chain slack is taken up. Put
ratchet knob in LOCK POSITION.
7. Put machine guard back in place.
8. Screw clutch handle (Figure 3) into clutch casting.
9. Attach cable guide hose (Figure 3).
NOTE! If inlet is not a manhole, disregard steps 10
through 12.
10. Set telescoping manhole guide pipe (Figure 4) for
depth of manhole. Place turnbuckle into manhole
opening.
11. Insert first cable through manhole guide pipe and at-
tach tool.
12. Put guide pipe into manhole and secure with “J”
bolt to turnbuckle of guide pipe.
13. Attach next length of cable and feed from front
through machine and through rear guide hose.
Figure 4 – Telescoping Manhole Guide Pipe
Turnbuckle
No. A-17 Telescoping
Manhole Guide Pipe
Manhole
Figure 3 – K-2000 Machine with Cable Guide Hose and Clutch Handle in Clutch Casting
Rear Wheel
Front Wheel (2)
Guide Hose
Gear Motor Plug
Cable Counter
Clutch Casting
Clutch Handle
Guard
FOR/OFF/REV
Switch
Latch (2)
Ratchet Knob
Motor Table
Engine/Generator
Drive Motor