Filter
Top Products
10
11
OperationOperation
Setting the Temperature
Dial Thermostat Models
• Turn the dial to the desired temperature.
• If the room’s temperature is below the
temperature selected on the thermostat
dial, the heater will turn on until the desired
temperature is reached.
• If the room’s temperature is above the
temperature selected on the thermostat dial,
the heater will not turn on. Once the room’s
temperature falls below the temperature
selected on the thermostat dial, the heater will
turn on.
Setting the Temperature
Programmable Thermostat Models
The thermostat normally displays the room’s
actual (measured) temperature.
• To view the setpoint, press one of the up/down
buttons once. The setpoint will appear for the
next 5 seconds.
• To change the setpoint, press one of the up/
down buttons until the desired temperature is
displayed. To scroll faster, press and hold the
button.
.
Dial Thermostat
•
4
0
•
5
0
•
6
0
•
7
0
•
8
0
•
F°
Programmable Thermostat
Setting the Clock and Day
Programmable Thermostat Models
• Press the Hour button to set the hour.
• Set the Min button to set the minutes.
• Set the Day button to set the day.
• Press Mode/Ret to exit.
Daylight Savings Time
The thermostat can automatically re-adjust its clock
at the Daylight Savings Time changeover. When this
function is enabled (On), the thermostat switches
to Daylight Savings Time on the second Sunday
of March and to normal time on the rst Sunday of
November.
NOTE: The function is disabled (default setting) when
the clock loses its setting.
• Press the Day button (3 seconds) until DLS appears
on the screen.
• Press the up/down button to toggle between On
(enabled) and Off (disabled).
• Press the Day button briey. The year setting is
displayed.
• Press the up/down button to set the current year.
• Press the Day button briey. The month setting is
displayed.
• Press the up/down button to set the current month.
• Press the Day button briey. The date setting is
displayed.
• Press the up/down button to set the current date.
• Press Mode/Ret to exit.