Filter
Top Products
14
ATTACH A RESMED PASSOVER HUMIDIFIER
Please refer to the illustrations in section J of the illustration sheet.
To connect your
S8 ESCAPE to a ResMed PASSOVER humidifier you need medium sized
21” (52 cm) air tubing.
1
Fill the
PASSOVER
with water and connect the medium
21” (52 cm)
and long
6’6” (2 m)
air tubing (
J-1
).
2 Place the S8 ESCAPE on top of the PASSOVER (J-2) and connect the free end of the
medium air tubing to the air outlet (J-3).
Note: To avoid water spilling into the
S8 ESCAPE, do not place it underneath the
humidifier.
3 Assemble your mask system and connect it to the free end of the long air tubing (J-4).
4 Connect the power cord to the socket at the rear of the S8 ESCAPE and plug the other
end into a power outlet.
Please refer to the ResMed Passover User’s Manual for further details.
!
WARNING
Make sure that the power cord and plug are in good condition and the equipment
is not damaged.
The
S8 ESCAPE is now ready for use with the PASSOVER.