Filter
Top Products
Regency Z2510 WarmHearth6
Unit Dimensions
INSTALLATION
8) NEVER leave children unattended when
there is a fire burning in the fireplace.
9) Allow the fireplace to cool before servicing.
Always shut off any electricity to the fire-
place while working on it. This will prevent
any possible electrical shock.
10) Regency is not responsible for any
smoking or related problems that may
result from the lack of adequate com-
bustion air. It is the responsibility of
the installer to ensure that adequate
combustion air has been provided for
the fireplace.
11)Regency Industries Ltd. does not warranty
“smoke free” operation nor are we respon-
sible for inadequate system draft caused
by mechanical systems, general construc-
tion conditions, inadequate chimney heights,
adverse wind conditions and/or unusual
environmental factors or conditions be-
yond our control.
12)DO NOT use a fireplace insert or any other
product not specified by Regency for use
with this fireplace.
13)Never, under any circumstances, install a
fireplace, chimney component or any ac-
cessories, supplied by Regency, that have
visible or suspected physical damage as a
result of handling or transportation. These
items should be inspected by a Regency
dealer or qualified factory representative to
ensure safe condition. When in doubt,
consult your Regency dealer.
14)It is recommended that power is supplied to
the terminal block of the unit to allow for the
installation of blower components now or at
a future date.
READ BEFORE YOU INSTALL
THE REGENCY WARMHEARTH
HIGH EFFICIENCY EPA
CERTIFIED FIREPLACE
This installation manual will enable you to make
a safe, efficient and dependable installation of
your fireplace and chimney system. Please
read and understand these instructions before
beginning your installation.
Do not alter or modify the fireplace or its com-
ponents under any circumstances. Any mod-
ification or alteration of the fireplace system,
including but not limited to the fireplace, chimney
components and accessories, may void the
warranty, listing and approvals of this system
and could result in an unsafe and potentially
dangerous installation.
PLEASE RETAIN THIS MANUAL FOR
FUTURE REFERENCE.
IMPORTANT: Please read and follow these
rules for safety.
1) Before starting your fireplace installation,
read these installation instructions careful-
ly to be sure you understand them in their
entirety. Failure to follow them could cause
a fireplace malfunction resulting in serious
injury and/or property damage.
2) Always check your local building codes.
The installation must comply with all local,
regional and state codes and regulations.
3) This model fireplace must be installed with
one of the chimney systems listed in the
Chimney Section in this manual. These
systems are intended for use as a residen-
tial type appliance. The chimney must
always vent to the outside of the building.
4) To ensure a safe fireplace system and to
prevent the build-up of soot and creosote,
inspect and clean the fireplace and chim-
ney prior to use and periodically during the
heating season.
5) Use solid fuel only. DO NOT use artificial
logs containing petroleum products, chem-
ical chimney cleaners, gas logs, gas light-
ers, salt contaminated wood or flame col-
orants in your fireplace. When using com-
pressed sawdust logs use only at 1/3
capacity since these get very hot and
expand.
6) DO NOT use charcoal or coal under any
circumstances.
7) NEVER use gasoline, gasoline-type lantern
fuel, kerosene, charcoal lighter fluid, or any
liquid to start or “freshen up” a fire in this
fireplace. Keep any flammable liquid a safe
distance from the fireplace.
DIMENSIONS AND
SPECIFICATIONS
The WarmHearth is a woodburning fireplace
featuring a self-contained heat-circulating sys-
tem and cast-iron door with large viewing
window. Options available are a Central Heat-
ing System or an Internal Blower. A set of
andirons are installed in the firebox to properly
position the fire, do not remove them.
Note: Illustrations shown reflect “typi-
cal” installations with nominal
dimensions and are for design
and framing reference only. Actu-
al installations may vary due to
individual design preferences.
However, always maintain mini-
mum clearances to combustible
materials and do not violate any
specific installation requirements.
The WarmHearth fireplace has been tested
and listed by Warnock Hersey Inc. to UL. 127
Standard for U.S. installations and ULC. S610
standard for Canadian installations. This unit
is intended for installation in convention-
al homes and buildings of conventional
construction, not in mobile homes.
This fireplace system is designed for installa-
tion in accordance with the National Fire
Protection Standard for chimneys, fireplaces
and solid fuel burning appliances; NFPA 211
and in accordance with codes such as the
BOCA Basic National Codes, the Standard
Mechanical Code, Uniform Building Codes,
Canadian National Building Codes or applicable
local codes.
Emissions from burning wood or gas could
contain chemicals known to the State of
California to cause cancer, birth defects or
other reproductive harm.