Filter
Top Products
UltraGlow G36D Zero Clearance Direct Vent Gas Fireplace
28
Diagram 3
Use the hook to pull the spring out until you
can put the hook into the slot on the bottom
door bracket. Repeat for 2nd spring. See
diagram 3.
Diagram 2
Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and
the door lip to ensure that the door sits securely
on the unit. Diagram 2.
To remove the fl ush door, reverse the above
steps.
Flush Louvers
1) Install each top by clipping the louver lip
onto the top louver brackets ensuring that
each individual louver is centered from side
to side.
2) The bottom louver has a hinge that is at-
tached (2 screws per hinge) to the lip on
bottom of the unit.
3) Open the bottom louver. Pull the Burner
ON/OFF control box from inside the bottom
of the fi replace and position the slots in the
bracket over the 2 screws on the left side
of the bottom louver. Push down to lock into
place. Tighten the screws.
Note: Top and bottom louvers are
different.
INSTALLATION
STANDARD FLUSH
DOOR
The standard fl ush door comes with a black
frame. To install the frame, simply hook the top
door fl ange onto the top of the unit and swing
the door towards the unit, diagram 1.
Diagram 1
Optional Flush Trim
Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then at-
tach trim to the top and bottom of Flush door.