Filter
Top Products
Regency Freestanding Woodstove
16
INSTALLATION
Side View
Front View
Front View
4) Install the two front air tubes into the holes
on the side channels. The notch goes on
the right hand side with the air holes facing
forward toward the door opening. If the
tube will not slide in easily, simply use a pair
of vise grips or pliers and tap it into place
with a hammer. A tighter fit will ensure the
tube will not move when the unit is burning.
Note: When cleaning the chimney re-
verse the above procedures, re-
moving the air tube and baffle
bricks and then replace them when
cleaning is completed.
Large Stoves F3100L and S3100L
The unit arrives with the first two air tubes (from
the front) and the 2 baffle bricks on the floor of
the firebox. The baffle bricks are positioned
first and then the air tubes are installed.
NOTE: If the first 2 airtubes are already
installed in the stove, they must
be removed in order to install the
Brick Baffles.
1) Slide the left baffle brick over the two rear
air tubes and then push it all the way to the
left side of the firebox.
Front View
2) Tilt the first Baffle Brick down and then slide
the 2nd Baffle Brick up and back. Reposi-
tion both baffle bricks flat on the air tubes.
3) Important: push both baffle bricks so
they are tight against the side walls.
Side View
BRICK FLUE BAFFLE &
SECONDARY AIR TUBE
INSTALLATION
The flue baffle system located in the upper area
of the firebox is removable to make cleaning
your chimney system easier. The brick baffles
must be installed prior to your first fire. Smoke
spillage and draft problems may occur if
the baffles are improperly positioned.
Check the position of the brick baffles on a
regular basis as they can be dislodged if too
much fuel is forced into the firebox.
The Large Stoves F3100L and S3100L are
shipped with two of the secondary air tubes
loose inside the firebox. They need to be in-
stalled after the brick baffle are installed. Follow
the directions below.
Small Stoves F1100S
1) If the two air tubes are installed continue on
to Step 2), if not, follow the instructions
below. Install the air tube into the holes in the
side channels. The notch goes on the right
hand side with the air holes facing toward
the door. Slide the tube into the left hand
side, as far as possible and then bring it
back into the hole on the right hand side until
it locks into position. If the tube will not slide
in easily simply use a pair of vise grips or
pliers and tap it into place with a hammer. A
tighter fit will ensure the tube will not move
when the unit is burning. See the diagram
for the large air tube installation (page 14),
though there are only two air tubes in the
small units.
2) Slide the left baffle brick over the front air
tube and then slide it back over the rear air
tube.
3) Tilt the left baffle brick up on top of the side
channel and it will leave enough room to
position the right baffle brick in the same
manner as Step 1) above. Then reposition
the left baffle brick flat on the air tube.
4) Important: push both baffle bricks so
they are tight against the side walls.
Note: When getting the chimney cleaned,
remove the baffle bricks for ac-
cess to the flue, then replace them
when cleaning is completed.