Regency F1100S Stove User Manual


 
Regency Freestanding Woodstove
10
INSTALLATION
Diagram 4
Diagram 2
Diagram 3
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
All units require either the pedestal or 4 legs
attached to the base. The F1100 and F3100
stoves require either the Airmate or Rear Heat
Deflector on top of the stove. Clearances to
combustible materials vary depending on wheth-
er the airmate or rear heat deflector is installed,
so be sure to check the clearance information
on pages 8 and 9.
Airmate Assembly
for F1100 & F3100
Small 850-105
Large 850-305
1) The airmate sits on top of the stove with the
slots in the sides fitting over the curved
deflector on the rear stove top. See diagram
1. Discard the Rear Heat Deflector that is
supplied with the unit, it is not required if the
airmate is installed.
2) Center the airmate and push it forward to the
front of the stove. The back of the airmate
should be level with the back and sides of
the rear heat shield. See diagrams 2 & 3.
Diagram 1
Rear Heat Deflector Assembly
for F1100 & F3100
Small 815-555
Large 815-556
The rear heat deflector is supplied with the
stove and must be installed unless the optional
airmate has been selected. It stops the heat
radiated from the flue collar from overheating
the rear wall. The rear heat deflector is installed
on top of the rear heat shield, as shown in
diagram 4.
S3100L Side Shield Adjustment
The left and right side shields are lowered for
shipping and handling. It allows for a handhold
on the top of the stove. Before placing in the Step
Stove in its final position, the side shields must
be raised.
Loosen the screws on the rear on the stove (3
per side), slide the side panel up as far as
possible and then secure by tightening the
screws.
Pedestal Assembly
Small 850-115
Large 850-315
1) For easier assembly, tip the stove on its
back (onto a soft surface to prevent scratch-
ing).
Hint: If you have chosen the Ash Drawer
option, remove the ash dump cover plates
before attaching the pedestal. See page 17
"Ashdrawer Kit Installation".
2) Remove the blanking plate if
a) you are not installing outside combus-
tion air or
b) outside air is to be brought in from the
rear of the stove.
3) Unscrew the 4 bolts in the under-side of the
stove. Align the holes in the corners of the
pedestal top with the corresponding holes
in the base of the stove. Fasten using a bolt
and washer for each corner.
4) Push the Regency logo
into the two holes
in the front bot-
tom left corner
of the pedestal
cover plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.
5) If not using ash drawer, then cover plate must
be installed. If using ash drawer, then disre-
gard cover plate.