Filter
Top Products
Programming With Code Search
Getting Codes From Your Universal Remote
11
1. Turn on the device you wish to program.
2. Press and hold CODE SEARCH until the INDICATOR
LIGHT lights, then release CODE SEARCH.
3. Press and release the device button for the device you
are programming (TV, VCR or CABLE). The
INDICATOR LIGHT will blink once.
For AUX, press AUX then the device button you are assigning
to AUX.
4. Press and release POWER until your device turns off.
Important: You may have to press POWER up to 200 times.
5. When your device turns off, press the ENTER button,
the INDICATOR LIGHT will turn off.
1. Press and hold CODE SEARCH until the INDICATOR
LIGHT lights, then release CODE SEARCH.
2. Press and release the device button for the device’s
code you are retrieving (TV, VCR or CABLE). The
INDICATOR LIGHT will blink once.
For AUX, press AUX then the device button for the code you
are retrieving.
3. Press and release CODE SEARCH. The INDICATOR
LIGHT will turn off.
4. Starting with 0 on the keypad press the number
buttons in order (0-9) until the INDICATOR LIGHT
blinks.
5. The number which causes the INDICATOR LIGHT to
blink is the first digit of your code.
6. Repeat step 4 until you have retrieved all three
numbers in the code.
If your TV, VCR, or Cable Box does not respond after you have tried all the codes for your brand, or
if your brand is not listed, try searching for your code by following the steps below.
If you need to find the three-digit code for your TV, VCR or Cable Box after your device is set-up
using Code Search, use this procedure.
OFF
…