Raypak 1505 Water Heater User Manual


 
HEAT EXCHANGERJACKETOTHER
GAS TRAIN
SAFETIES
OPERATING CONTROLS
ASME, National Board Registered, 160 PSI HLW Stamp
Heat Exchanger Tubes Cupro Nickel
Bronze Headers
Stainless Steel Condensing Heat Exchanger U Stamp
Pressure Relief Valve 125 PSI
(Mounted on Outlet) (Currently Shipped Loose)
Temperature & Pressure Gauge
Pump - Primary 120V, Single-Phase
Indoor/Outdoor Certified
Vent Terminal Outdoor
Through-the-Wall
Fully-Enclosed Controls
Combustible Floor Rated
120V Power Supply with 120V/24V Transformer
On/Off Switch
Programmable Pump Time Delay, Single-Phase Included in TempTracker Mod Controller
Terminal Block Connections Enable / Disable
(Front mounted) External Interlocks
0-10 VDC Setpoint/Direct Drive Input
LCD diagnostic display with 16-Event History (2x20 character display, reads in plain English)
Status Display Lights (4)
Temperature Controller with 3 Water Sensors TempTracker Mod
Multiple Heater Controller TempTracker Mod+, up to 16 heaters
Hot Surface Ignition System 1-try
3-try
High/Low Gas Pressure Switches
Blocked Vent and Air Pressure Switches
High Limit Switch Manual Reset, Fixed
Manual Reset, Adjustable
Automatic Reset, Adjustable (Shipped Loose)
Low Water Cut-Off, 24V With Manual Reset and Test Buttons
Flow Switch
Combination Gas Valve
Combustion Air Blower
Additional Safety Valve Motorized (externally mounted)
Solenoid (externally mounted)
CSA-Certified Efficiency 97% at Full Fire
Air Filter
TruSeal Direct-Vent Ready
PVC Vent Adapter Option D-32 (Factory installed only)
Alarm System
CSD-1 / GE GAP Control System
Low NOx Meets all current requirements
Cold Water Run - Variable Speed Pump Prevents condensation in primary heat exchanger
WHP
= Standard = Optional
Raypak, Inc. • 2151 Eastman Avenue, Oxnard, CA 93030 • phone: (805) 278-5300 • fax: (800) 872-8725 • www.raypak.com
Cat. No. 6200.12-E Effective 4-1-11 Replaces 1-1-11
6200.12-E_XTherm Brochure 8 page 3/29/11 10:58 AM Page 1