Filter
Top Products
11
OUTDOOR INSTALLATIONS
Step 2: Tighten the (4) screws (Shown below) until
they come in contact with the unit jacket top,
then evenly tighten all (4) screws to secure
to unit.
MODELS 926-1758
Heaters are shipped with outdoor vent terminal
factory installed.
MODELS 2100-4001
These units are not certified for outdoor installa-
tion.
VENTING
Fig# 8166
Fig# 8233
MODELS 514-824
Step 1: Lower outdoor "Stackless" top onto unit.
Position top so it is centered on unit from
side-to-side and front-to-rear.
MODELS 181-401 and 182-400
VENT TERMINAL (Outdoor) Stackless Top Installa-
tion
1. Insert tabs into
keyhole (4 places).
Fig. #RP8280.1
MODEL 133
Step 1: Remove the front (4) screws.
Step 2: Line up outdoor top vent opening over heater
vent opening.
Step 3: Lower outdoor top onto unit lining up slots in
the outdoor top with screws holes in jacket top.
Step 4: Reinstall (5) screws to secure jacket top and
outdoor top to unit.
Fig. #8114
2. Snap tabs into keyholes
so as not to pull out.
Pagoda Top (Shipped Loose with Heater)
Fig# 8278.1