Filter
Top Products
6 Basic Operation Instructions Dolphin
MAGNETIC KEY LOCK SYSTEM
1. To arm the locking system, hold the magnetic key on or near the key
symbol on the Dolphin front panel. See figure 1. The system will beep
and automatically power itself down. No LEDs should be lit.
2. To turn the power chair back on, press the On/Off Switch. The system
will power on, but the locking system needs to be disarmed before normal
operation can occur. The key symbol will flash, indicating that the system
should be disarmed.
3. To disarm the lock, put the magnetic key on or near the key symbol. The
LED will stop flashing, and normal operation may resume. If the locking
system is not disarmed within one minute, the Dolphin will shut itself
off.
JOYSTICK OONAPU
If the power chair is powered up while the joystick is not in the neutral
position, the System Status LED will flash for as long as the condition persists
up to a maximum of five seconds. After five seconds, a Fault Flash Code is
signaled on the System Status LED, and the Remote Status LED will flash.
To clear the fault, power down, put the joystick in neutral, and power the
system back on.
DRIVE PROGRAM SELECTION
The Dolphin can control up to five drive programs. Drive Program 1 is
configured as the slowest, and Drive Program 5 is configured as the fastest.
To select the preferred drive program, press the Drive Program Select Switch.
The selected drive program will be displayed on the 7-segment display. See
figure 1. Each press of the Drive Program Select Switch will increase the
drive program to the next level until it cycles back to Drive Program 1.