Filter
Top Products
Page 26
7034-106E
September 1, 2008
R
Mt. Vernon Pellet Stove (AE)
H. Quick Start Guide
RA
Set at
P
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
2. Highlight “FUEL TYPE” using the “UP/
DOWN” buttons to the right side of the
display. Press “SELECT”.
A to/ an al/ ff
ser Settings
Fuel Type
MENU
Set Comfort Level
3. Scroll down and highlight “HARD-
WOOD PELLET” or your fuel type.
S nflo er Seeds
heat
F L SLC
Soft ood Pellet
ard ood Pellet
5. Press “DONE” to confirm fuel
change.
CFR FL CA
Please empt hopper
of old f el t pe and
ens re fire o is lean
Please refer to
se tion in man al
DONE
2. Highlight “AUTO/MANUAL/OFF”.
Press “SELECT”.
ser Settings
Fel pe
Set Comfort Level
A to/ an al/ ff
3. Highlight “MANUAL”. Press “SELECT”.
A/AAL S S
an al
ff
A tomati
an al
CHOOSING FUEL TYPE
TURNING ON APPLIANCE
7. Fill the hopper with fuel, and if the
hopper was completely empty, or has
run out of fuel, throw approximately
1/2 cup of pellets into the firepot.
8. Be sure the hopper lid and glass
door are both closed.
1. At the starting screen, press “MENU”.
Function Buttons
ttons
Up
Down
RA
Set at
P
HEAT OUTPUT
MENU
Room
Tem p
Wall Control for Reference
6. Press “DONE” twice or wait 15 sec-
onds for starting screen to reap-
pear.
4.
Press “DONE” twice or wait 15 seconds
for starting screen to reappear.
RA
Set at
P
MENU
4. Now press “SELECT” to choose new
fuel
RA
Set at
P
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
2. Highlight “TEMP UNITS F/C” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
CHOOSING TEMP UNIT:
°F or °C
4. Press “DONE”. Press “DONE” again,
or wait 15 seconds for starting screen
to reappear.
3. Press the “UP” or “DOWN” button
to set desired temperature unit and
press “SELECT”..
SR S S
Flame eight Ad st
emp ifferential
emp nits F/C
A to/ an al/ ff
Fel pe
Set Comfort Level
ser Settings
2. Highlight “USER SETTINGS” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
NOTICE:
Any button pressed will turn on the backlight. Wall control will automati-
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the “CONFIRM FUEL CHANGE” screen.