Filter
Top Products
Page 32
7036-135G
November 22, 2011
R
Mt. Vernon Pellet Insert (AE)
READY
71
Set at: 74
12:30 PM
HEAT OUTPUT
MENU
Hold at:
Medium High
1. At the starting screen, press “HEAT
OUTPUT”.
2. Use the “UP” button to change “HEAT
OUTPUT LEVEL” to ”MEDIUM-HIGH”.
SETTING HEAT OUTPUT
1. Press and hold “UP” or “DOWN” but-
ton to set desired temperature.
74
ºF
2. Press “HOLD TEMP”.
SETTING COMFORT LEVEL
READY
71
Set at: 68
12:30 PM
HEAT OUTPUT
MENU
NOTE: Set temperature must be 3
degrees higher than room
temperature for appliance to
start.
SET COMFORT LEVEL
ON HOLD
RESUME
DONE
74
ºF
3. Press “DONE”.
3. Press “DONE” twice or wait 15 seconds
for starting screen to re-appear.
HOPPER OUT OF FUEL
SHUTDOWN
71
Set at: 74
12:30 PM
HEAT OUTPUT
MENU
Hold at:
STARTUP
71
Set at: 74
12:30 PM
HEAT OUTPUT
MENU
Hold at:
Min Firepot Temp
SERVICE
RETRY
ERROR LIST
1. If the appliance has stopped operat-
ing, check the wall control screen. If
it is showing “Min Firepot Temp” the
hopper has run out of fuel.
2. Fill the hopper with fuel and press the
“RETRY” button twice. The fi rst time
turns on the back light, the second
time starts the retry function.
3. If the wall control screen changes to
a “SHUTDOWN” screen that means
your appliance has not completed the
full shutdown cycle. Depending on
where it was in the cycle it can take
from one to ten minutes to restart.
When the shutdown cycle is complete
the wall control screen will display
“STARTUP”. Continue to Step 4.
4. If the wall control screen changes to
a “STARTUP” screen after pressing
“RETRY” that means your appliance
has already completed the shutdown
cycle. You must wait until the wall con-
trol screen displays the startup screen
and then put 1/2 cup of pellets in the
fi repot for a quick restart.
5. Be sure the hopper lid and glass door
are both closed.