Filter
Top Products
Quadra-Fire • HUDBAY-INS • 7008-115 Rev. o • 8/1122
A. Fuel Conversion
• Make sure the appliance is compatible with available gas
types.
• Conversions must be made by a qualifi ed technician
(NFI certifi ed or factory-trained) using Hearth & Home
Technologies specifi ed and approved parts.
9
9
Gas Information
Kit contents: Replacement orifi ce; replacement pilot
injector; valve regulator; conversion label.
Tools required: Ratchet with 7/16 in. (11 mm) socket
and 2 in. - 4 in. (51-102 mm) extension: power drill (a 90°
handle is helpful); #2 Phillips bit; 5/32 in. (4 mm) Allen
wrench; 5/8 in. (16 mm) open end wrench.
Remove right and left twigs and right and left rear logs
from the burner pan, if installed. Remove the two nuts
that secure the burner pan to the burner support with the
ratchet and socket.
Note: Gas conversions should only be performed by a
qualifi ed service person, and/or where required by state
and local codes, licensed installer/service technician. In
the Commonwealth of Massachusetts, installation must be
performed by a licensed plumber or gas fi tter.
B. Converting to LP Gas
Figure 9.1
2 NUTS HOLDING
2 NUTS HOLDING
BURNER PAN
BURNER PAN
Figure 9.2
Figure 9.3
Figure 9.4
Lift the burner up and out of the fi rebox opening.
Remove the three screws on the front of the burner sup-
port. Set screws aside.
3 SCREWS
3 SCREWS
Slide the burner support to the left to access the orifi ce.
BURNER SUPPORT SCREWS
BURNER SUPPORT SCREWS