PVI Industries PV 413A Water Heater User Manual


 
PV 413 8/05 817-335-9531 800-433-5654 FAX 800-880-2019 www.pvi.com
START-UP REPORT
POWER VT
®
WATER HEATERS OR BOILERS
Warning: Startup must be performed by a qualified service installer, service agency or the gas supplier.
Model Number:
Serial Number:
Job Name:
Address:
GENERAL INFORMATION
Restart? Yes No Installation is: New Replacement/Renovation Indoor Outdoor
Primary operating voltage supply: VAC Voltage from neutral to earth ground: (should be zero)
Thermostat Setting: °F Thermostat Setting: °F Hi-Limit Setting °F
Is the T & P Relief Valve plumbed to a suitable drain? Yes No
BOILER INSTALLATIONS (Closed Loop Heating System)
Boiler water supply and return piping size Is there a Primary (boiler bypass) loop? Yes No
Primary (boiler bypass) loop contains: Modulating 3-way valve Manual valve No valve
What is the horsepower of the primary (boiler loop) circulator pump? VFD? Yes No
What is the location of the primary circulator pump? Downstream from boiler Upstream from boiler
Is there a balancing valve (circuit setter) in the primary loop? Yes No
Supply water temperature: °F Return water temperature: °F
What is the horsepower of the secondary (main heating loop) circulator pump? VFD? Yes No
What is the location of the secondary circulator pump? Downstream from boiler Upstream from boiler
Is there a balancing valve (circuit setter) in the secondary loop? Yes No
WATER HEATER INSTALLATIONS
Type of piping connected to heater: Copper Brass Galvanized
Is there a check valve in the supply water piping? Yes No
Is there a water softener on the cold water supply? Yes No Operational? Yes No
Is there a mixing valve on the hot water supply? If yes; temperature setting: °F No
Is there expansion relief in the cold water supply? If yes, what type: tank valve No
Is there a recirculation loop? Yes Circulating pump horsepower: No
Is there a floor drain in the room? Yes No
Page 1 of 2