Procom SFE23RE-O Indoor Fireplace User Manual


 
7
(Adaptor NOT permitted in Canada)
Under CZ22.2 NO. 0 standard
6
6. Flame Effect setting:
(1) Flame speed
After selecting MANUAL mode or AUTO mode, the
flame symbol will flash, for slow flame effect, press
button, for faster flame effect, press button.
(2) Flame brightness
Press SET button, when the lamp symbol flashes,
press button to decrease the flame brightness
and button to increase the flame brightness.
7. For Flame Effect only:
Select MANUAL mode, then set the Heating level to
no heating level or select AUTO mode and then set
temperature to lowest setting.
8. Manual ON/OFF button
If you cant find your Remote Control or the Remote
Control is damaged, you can use manual ON/OFF
button to manual turn on/turn off your heater.
2.The Clock setting :
Press the CLOCK button, the figure shown on clock will
flash. Press or to set the hour. After the hour has
been set, press the CLOCK button again to set the
minutes. After the minutes has been set, press the CLOCK
button, the clock will indicate the set time.
3.The Timer setting :
Press the TIMER button, the word TIMER will appear on
the transmitter, next press or to adjust the time, to
add 30 minutes increments press the button again. After
the timer has been set, press TIMER button again, the
word TIMER will flash and the timer will return to time.
4. Key-Press Lock setting (child proof):
To lock, press the LOCK button, there will be a symbol,
which means that the transmitter is in a lock position. To
unlock, press once immediately followed by pressing
the LOCK button .
5. Heating Level setting
Select the MANUAL model and press SET to chosse the
heating level setting, the symbol will flash. Then
press or to select full, half or no heating.