Filter
Top Products
________________________________________________________________
V1.0
3 / 21
Document 020-1156-00 Rev B
1. If the message is receives correctly it will send “+” (02Bh) followed by “CR” (00Dh)
2. If the message is receives incorrectly it will send “-” (02Dh) followed by “CR” (00Dh)
3 Protocol 1: with ID
3.1 Command Description
Length: Total Byte of Message excluding “CR”
TV ID Identification for each of TV
Command
Type
Identify command type,
“s” (0x73h) : Set Command
“g” (0x67h) : Get Command
“r” (0x72h) : Reply Command
“p” (0x70h) : RCU Pass-through
“+” (0x2Bh) : Valid command Reply
“-“ (0x2Dh) : Invalid command Reply
Command: Function command code: One byte ASCII code
Value[1~3]: Three bytes ASCII that defines the value
CR 0x0D
3.2 Set-Function Listing
The PC can control the LCD Monitor for specific actions. The Set-Function command allows you to
control the LCD monitor behavior in a remote sit through the RS232 port. The Set-Function packet
format consists of 11 bytes.
Set-Function description:
Length: Total Byte of Message excluding “CR”
TV ID Identification for each of TV
If we want to set all TV settings, TV ID can use “99” to achieve, and it
will not have Reply command on this function.
Command
Type
Identify command type,
“s” (0x73h) : Set Command
Command: Function command code: One byte ASCII code
Value[1~3]: Three bytes ASCII that defines the value
CR 0x0D
Set-Function format
Send: (Command Type=”s”)
Name
Lengt
h
ID Command
Type
Comman
d
Value
1
Value
2
Value
3
CR
Byte
Count
1 Byte
2
Byte
1 Byte 1 Byte 1 Byte
1 Byte
1 Byte
1
Byte
Bytes
order
1 2~3 4 5 6 7 8 9
Reply: (Command Type=”+” or “-”)
Name
Lengt
h
ID Command
Type
CR
Byte 1 Byte
2 1 Byte 1