Filter
Top Products
________________________________________________________________
V1.0
16 / 21
Document 020-1156-00 Rev B
Remote Control
68 000: Disable Lock
001: Enable
002: Pass
through
Key Pad function
8
69 000: Disable Lock
001: Enable
Menu Key function
8
73 000: Disable Lock
001: Enable
Power Key
function
8
74 000: Disable Lock
001: Enable
5V
8 g m 6D 000~50
12V
8 g n 6E 000~120
Ambient Sensor
9 g p 70 0000 ~ 2000
Thermal Sensor
9 g q 71 -055 ~ +125
Operating Time
A g v 76 0 ~ 65535 Hour
4 Protocol 2 : without ID
4.1 Set function listing
The PC can control the LCD Monitor for specific actions. The Set-Function command allows you to
control the LCD monitor behavior in a remote sit through the RS232 port. The Set-Function packet
format consists of 5 bytes. Note that the “Value” byte is always = 00.
Set-Function description:
Length: Total bytes of message = 5 ASCII (35H) excluding “CR”
Command: Function command code: One byte ASCII code
Value[1~3]: Three bytes ASCII that defines the value
Set-Function format:
Name Length Command
Value1
Value2
Value3
CR
Byte Count
1 Byte 1 Byte 1 Byte
1 Byte
1 Byte
1 Byte
Bytes order
1 2 3 4 5 6
All Set-Function from PC to Monitor (ASCII)
Name Length Command
Value1
Value2
Value3
CR
Byte Count
5 1 Byte 1 Byte
1 Byte
1 Byte
00D
Bytes order
1 2 3 4 5 6
Example: Set Mute-ON command (ASCII)
Name Length Command
Value1
Value2
Value3
CR
Byte Count
5 6 0 0 0 00D
Bytes order
1 2 3 4 5 6