Philips AMW Air Conditioner User Manual


 
MODEL: AMW 45, 60
! Start air conditioner. Point the remote controller at the fan coil and press "ON/OFF" button.
! Select operation mode. Press "Mode" button to select any of the following modes: "Cool",
"Dry" or "Vent".
! Temperature setting. Press "+" or "-" button to set desired temperature.
! Select fan speed. Press "Fan control" button to select desired fan speed.
! Select airflow direction. Press "Louver control" button to set position of horizontal vane or
set it to auto swing.
! Set Timer. If desired, set timer on or off by pressing "Time Control" button, followed by "+" or
"-" button to select time before air conditioner starts or stops operating.
! Sleep mode. Press "Sleep" button to select sleep mode. A s the name suggests, it is used
during sleeping. The room temperature would be adjusted by 2°F up from set temperature to
save power.
2) FUNCTIONS
AUTO
This allows the air conditioner to operate automatically at a pre-set temperature. Cooling will be
affected when room temperature is above 82°F (28°C).
COOLING
When activated, the fan will automatically operate at high speed for 5 minutes before operating at the
set speed. During cooling if the humidity in the room is very high (RH above 80 %), condensation
may occur at the air discharge louver. It is advisable to operate the fan at high speed under this
condition.
DRYING
When activated, the air conditioner will operate on and off intermittently. The fan will automatically
operate at low speed. Fan speed, temperature settings and sleep mode will be by-passed. This
function will not operate if the room temperature is lower than 59°F (15°C).
FAN ONLY
The following speed can be selected. Low mid high auto. At auto, the fan speed will be
automatically selected by the micro-processor, depending on the difference between factory pre-set
and room temperature.
TIMER
This feature allows the air conditioner to be automatically SWITCH ON or SWITCH OFF after a pre-
determined time.
CLOCK
This is for setting the real time to facilitate the operation of the timer.