Filter
Top Products
Adjustment
7
1.04.03 Height of the bottom feed-dog
Requirement
With the stitch length set at "0", the bottom feed dog must protrude over the needle plate
as high as the teeth when at TDC.
● Set stitch length "0".
● Bring the bottom feed dog to its TDC by turning the handwheel.
● Adjust feed dog carrier 1 (screws 2) in accordance with the requirement.
If required, the feed dog height can be reduced a little on machines without a
bottom feed lifting phase (without P).
Fig. 1 - 03
21