Filter
Top Products
9 - 1
Setting up
9 Setting up
All instructions and regulations in this instruction manual must be observed.
Special attention must be given to all safety regulations!
All setting-up work must only be done by personnel with the necessary
training. For all setting-up work the machine must be isolated from its power
supply by turning off the on/off switch or removing the machine plug from the
electric power socket!
9.01 Inserting the needle
Fig. 9 - 01
1
1
Switch off the machine!
Danger of injury if the machine is started accidentally!
Only use needles from the system intended for the machine, see Chapter 3
Specifications.
● Raise the needle bar and loosen screws 1.
● Insert the needle as far as possible (the long groove of the left needle must be pointing to
the right and the long groove of the right needle to the left).
● Tighten screws 1.
The selection of the needles depends on the machine version and the threads
and material being used, see Chapter 3 Specifications.
Fig. 9 - 02
1
1
On machines without needle switch-off On machines with needle switch-off -720/02