EXTERIOR FINISH
4HEEXTERIORFRAMEANDSASHAREPROTECTEDBYALUMINUMCLADDINGWITHOURTOUGH%NDURA#LAD
®
OR%NDURA#LAD0LUSBAKEDONFACTORY
lNISHTHATNEEDSNOPAINTING#LEANTHISSURFACEWITHMILDSOAPANDWATER3TUBBORNSTAINSANDDEPOSITSMAYBEREMOVEDWITHMINERAL
spirits. DO NOT use abrasives. DO NOT scrape or use tools that might damage the surface.
5SEOFINAPPROPRIATElNISHESSOLVENTSBRICKWASHORCLEANINGCHEMICALSWILLCAUSEADVERSEREACTIONSWITHWINDOWANDDOORMATERIALSAND
voids the Limited Warranty.
CARE AND MAINTENANCE
#AREANDMAINTENANCEINFORMATIONISAVAILABLEINTHE0ELLA/WNERS-ANUAL9OUCANOBTAINANOWNERSMANUALBYCONTACTINGYOURLOCAL
Pella retailer. This information is also available at www.pella.com.
IMPORTANT NOTICE
"ECAUSEALLCONSTRUCTIONMUSTANTICIPATESOMEWATERINlLTRATIONITISIMPORTANTTHATTHEWALLSYSTEMBEDESIGNEDANDCONSTRUCTEDTO
properly manage moisture. Pella Corporation is not responsible for claims or damages caused by anticipated and unanticipated water
INlLTRATIONDElCIENCIESINBUILDINGDESIGNCONSTRUCTIONANDMAINTENANCEFAILURETOINSTALL0ELLAPRODUCTSINACCORDANCEWITH0ELLAS
INSTALLATIONINSTRUCTIONSORTHEUSEOF0ELLAPRODUCTSINWALLSYSTEMSWHICHDONOTALLOWFORPROPERMANAGEMENTOFMOISTUREWITHINTHE
wall systems. The determination of the suitability of all building components, including the use of Pella products, as well as the design
and installation of flashing and sealing systems are the responsibility of the Buyer or User, the architect, contractor, installer, or other
construction professional and are not the responsibility of Pella.
Pella products should not be used in barrier wall systems which do not allow for proper management of moisture within the wall systems,
SUCHASBARRIER%XTERIOR)NSULATIONAND&INISH3YSTEMS%)&3ALSOKNOWNASSYNTHETICSTUCCOOROTHERNONWATERMANAGEDSYSTEMS
%XCEPTINTHESTATESOF#ALIFORNIA.EW-EXICO!RIZONA.EVADA5TAHAND#OLORADOPella makes no warranty of any kind on and
assumes no responsibility for Pella windows and doors installed in barrier wall systems. In the states listed above, the installation
of Pella products in barrier wall or similar systems must be in accordance with Pella’s installation instructions.
0RODUCTMODIlCATIONSTHATARENOTAPPROVEDBY0ELLA#ORPORATIONWILLVOIDTHE,IMITED7ARRANTY
TROUBLESHOOTING - Adjustable Strike Latching Issues
5"#4
"EKVTUBCMFTUSJLFTIJN
TJEFWJFX
4USJLF
GSPOUWJFX
"EK4USJLF4IJN
FOEWJFX
'BDUPSZ
JOTUBMMFE
TJEF
4JEFUPCF
VTFEJO
*TTVF
Issue 2:
Door needs to close more
tightly against the weather-
strip. Remove
THESTRIKEAND
ADJUSTABLESTRIKE
shim. Remove
the tabs from the
ADJUSTABLESTRIKE
shim and install
SOTHATTHETHICKER
side is visible at
THESTRIKEEDGE
2EINSTALLTHESTRIKE
Issue 1:
Door is difficult
to latch. Remove
THESTRIKEAND
ADJUSTABLESTRIKE
shim then reinstall
THESTRIKE
Note: Troubleshooting is for Architect Series
®
and Designer Series
®
only.