Filter
Top Products
APPLYING HEAD DRIP FIN - REQUIRED FOR VERTICAL
MULLION APPLICATIONS
A. Apply a bead of sealant along the whole
width of the mulled composite behind the
exterior rib.
B. On vertical mulls, cut the head drip to the
width of the units. Attach the head drip to
the top of units aligning the ends and seal to
the frame on both ends.
Note: The head drip may either be riveted to
the fin or installed when the unit is installed.
If the head drip is being installed with the
unit, perform Step A at this time.
#
"
&
9
5
&
3
*
0
3
*
/
5
&
3
*
0
3
FINISH
The interior and exterior frame and sash are protected by a powder coat baked-on finish that
requires no painting. Clean this surface with mild soap and water. Stubborn stains and deposits
may be removed with mineral spirits. DO NOT use abrasives. DO NOT scrape or use tools that
might damage surface.
Use of inappropriate solvents, brickwash or cleaning chemicals will cause adverse reactions with
window and door materials and voids the Limited Warranty.
CARE AND MAINTENANCE
Care and maintenance information is available by contacting your local Pella sales
representative. This information is also available on www.pellaimpervia.com.
IMPORTANT NOTICE
Because all construction must anticipate some water infiltration, it is important that the wall system
be designed and constructed to properly manage moisture. Pella Corporation is not responsible
for claims or damages caused by anticipated and unanticipated water infiltration; deficiencies in
building design, construction and maintenance; failure to install Pella
®
products in accordance with
Pella installation instructions; or the use of Pella products in wall systems which do not allow for
proper management of moisture within the wall systems. The determination of the suitability of all
building components, including the use of Pella products, as well as the design and installation of
flashing and sealing systems are the responsibility of the Buyer or User, the architect, contractor,
installer, or other construction professional and are not the responsibility of Pella.
Pella products should not be used in barrier wall systems which do not allow for proper
management of moisture within the wall systems, such as barrier Exterior Insulation and Finish
Systems, (EIFS) (also known as synthetic stucco) or other non-water managed systems. Except
in the states of California, New Mexico, Arizona, Nevada, Utah, and Colorado, Pella makes no
warranty of any kind and assumes no responsibility for Pella windows and doors installed
in barrier wall systems. In the states listed above, the installation of Pella products in barrier
wall or similar systems must be in accordance with Pella installation instructions.
Product modifications that are not approved by Pella Corporation will void the Limited Warranty.
Part Number: 803V0102
B
A