Filter
Top Products
8 Pelco Manual C565M-B (7/98)
4.0 OPERATION
Refer to Figure 2.
1. Set the power switch to the ON position to activate the controller. The pilot
lamp will light when power is applied.
2. If your model has a PAN switch, set it in either the AUTO position to select
auto scan (pan) or the MANUAL position to use the joystick.
3. Operate the pan function by moving the joystick LEFT or RIGHT.
4. Operate the tilt function by moving the joystick UP or DOWN.
5. Adjust the TILT SPEED or PAN SPEED by rotating the respective knobs (on
some models). The clockwise direction increases speed and counterclock-
wise decreases speed. The PAN SPEED control can be used with the PAN
switch in either position.
6. On some models, the camera lens can be operated by three switches and one
lens speed control. The lens must have motorized zoom, focus, and iris capa-
bilities in order for these lens control functions to operate. The switches are
spring-loaded to the center or off position and control the following:
Switch function Up position Down position
ZOOM TELE WIDE
FOCUS NEAR FAR
IRIS OPEN CLOSE
The lens SPEED control will adjust the speed of all lens functions simulta-
neously, not individually. Rotating the knob in the clockwise direction increases
speed and counterclockwise decreases speed.
Figure 2. Model MPTV1510PAZ Front Panel
ON
OFF
MPTV1510PAZ
MANUAL
PAN
AUTO
TILT
SPEED
PAN
SPEED
UP
LEFT
RIGHT
DOWN
ZOOM
TELE
WIDE
FOCUS
NEAR
FAR
IRIS
OPEN
CLOSE
SPEED