Filter
Top Products
C3426M-E (3/09) 27
SW1-8: Day/Night Operation (DW models only)
NOTE: On CW models, SW1-8 is unused and does not affect camera operation.
DW model cameras regularly check the brightness level of the field of view to determine when to switch
between day (color) and night (black-white) operation. Use SW1-8 to set the general light levels at which
the camera will automatically switch.
Set SW1-8 to ON (dark) to use standard thresholds to switch between color and black-white operation.
This is the default setting.
Set it to OFF (dusk) to use higher light thresholds to switch between color and black-white operation.
Actual brightness threshold levels are affected by camera angle, amount of zoom, field of view, lens, and
type of lighting. The switching process lasts from 7 to 10 seconds.
NOTE: If the camera switches between day/night mode at least three consecutive times within a short
time period, the camera will remain in the last mode for 10 minutes. To override this 10-minute pause,
cycle the power or expose the camera to an extreme light level change (for example, from very dim light to
very bright light).
Figure 14 and Table H show how the camera switches between color and black-white operation for each
setting.
Figure 14. DW Models Threshold Switching Levels
NOTE: These switching thresholds are approximate and were measured using a 3.0 to 9.5 mm lens at
f/1.0. Use the thresholds in Table H as a guide when installing the unit.
Table H. DW Models Approximate Switching Thresholds
Dark (ON) Dusk (OFF)
Color to B-W 1.0 lux 4.0 lux
B-W to Color 3.0 lux 7.0 lux
B-W
MODE
COLOR
MODE
FALLING LIGHT LEVEL
RISING LIGHT LEVEL
B-W
MODE
COLOR
MODE
DUSK
4.0 lux
7.0 lux
B-W
MODE
COLOR
MODE
FALLING LIGHT LEVEL
RISING LIGHT LEVEL
B-W
MODE
COLOR
MODE
DARK
1.0 lux
3.0 lux