Filter
Top Products
2 C267M-D (1/08)
IMPORTANT SAFETY INSTRUCTIONS
1. Installation and servicing should only be done by qualified service personnel and conform to all local
codes.
2. Installation shall be done in accordance with all local and national electrical and mechanical codes
utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maximum
specified load.
DESCRIPTION
The EM2400 light duty wall mount has been engineered for use with light- to medium-weight cameras and
EH4010/EH4014/EH4018 enclosures. It is designed for mounting indoors on any wall or vertical surface
and is capable of supporting loads up to 20 lb (9 kg).
The EM2400 has an adjustable head that allows mechanical positioning of the camera/enclosure.
In addition to the removable front end cap, there is also a half-inch diameter cable feedthrough hole and
an opening in the mounting plate for concealing the wiring.
MODEL
EM2400 Light duty indoor wall mount, gray.
INSTALLATION
To install the EM2400 enclosure mount, perform the following steps.
1. Drill holes in the mounting surface using the mount as a template, and attach the mount securely
with the recommended fasteners. Fasteners to secure the mount to the desired mounting surface
are not supplied.
2. Attach the enclosure or camera securely with the two 1/4-20 hex head screws provided.
3. Loosen the hex head bolts on the swivel head and adjust for pan rotation (360 degrees) and tilt angle
(90 degrees up or down). Tighten bolts and lock into place.
WARNINGS:
• This mount is intended for use in indoor applications only. Do not mount outdoors.
• Make certain that the mounting surface is able to support the full load of the mount, enclosure,
and camera.