Filter
Top Products
18
ECP190 DOOR CONTROLLER with
KEYPAD ACCESS CODE CONTROL
TOP POINTS TO REMEMBER
■ Programming is effected directly via the keypad.
■ Master Code (Programming Access Code) is always a 5 digit number.
■ Master Code is always stored in Slot N
o
. 06.
■ Keypad Access Codes are always 5 digit numbers.
■ Keypad Access Codes can be stored in Slot N
os
. 03 - 05 and 07 - 30 only.
SET-UP ON INSTALLATION
Proceed exactly as detailed before in section ECP Door Controller with Access Pass Control. Stop when you have
completed Step 3. Then - Turn off programming switch SW1 in the Door Controller.
PROGRAMMING KEYPAD ACCESS CODES
Keypad Access Codes must be 5 digits in length and can only be stored in Slot Numbers 03-05 and 07-30.
Example: You want to program codes: 46296 for Alan
78327 for Tony
32534 for Alex
Enter the Master Code on the keypad:
Beeps every 4 seconds indicate that you have accessed Programming Mode.
After a beep enter on the keypad:
A sharp beep confirms that Alan’s code is recorded. Programming mode beep - every 4 seconds - resumes.
After a beep enter on the keypad:
A sharp beep confirms that Tony’s code is recorded. Programming mode beep - every 4 seconds - resumes.
After a beep enter on the keypad:
A sharp beep confirms that Alex’s code is recorded. Programming mode beep - every 4 seconds - resumes.
Note Carefully:
Never program a keypad access code into Slot Numbers 01, 02 or 06.
DELETING KEYPAD ACCESS CODES
Example: You want to delete Alan’s code 46296 which is stored in Slot N
o
. 03
You want to delete Alex’s code 32534 which is stored in Slot N
o
. 07
Enter the Master Code on the keypad:
Beeps every 4 seconds indicate that you have accessed Programming Mode.